釀酒設備中的風機是設備配件的一個重要部分，因此我們做好日常的維護也是很有必要的。接下來一起看看怎么做吧。
The fan in the brewing equipment is an important part of equipment accessories, so it is necessary for us to do a good job in daily maintenance. Now let's see how to do it.
釀酒設備風機的使用環境應始終保持清潔，風機表面應保持清潔，進風口和出風口不應有雜物。定期風機及管道內的灰塵等雜物。只能在風機全正擋的情況下操作。同時，要保持供電設施有足夠的容量和穩定的電壓。嚴禁無相位運行。
The use environment of the fan of wine making equipment should always be kept clean, the surface of the fan should be kept clean, and the air inlet and outlet should be free of debris. Regularly remove the dust and other debris in the fan and pipe. It can only be operated with the fan in full positive gear. At the same time, it is necessary to keep the power supply facilities with sufficient capacity and stable voltage. Operation without phase is strictly prohibited.
釀酒設備的供電線路必須是專用線路，不得使用臨時線路長期供電。風機運行過程中發現風機有異響，電機發熱嚴重，外殼帶電，開關跳閘，無法啟動等。所以立即停機檢查。為確保，風機運行期間不允許進行維護。維修后，應進行五分鐘左右的試運轉，確認無異常現象后，方可啟動機器。
The power supply line of wine making equipment must be special line, and temporary line shall not be used for long-term power supply. During the operation of the fan, it is found that the fan has abnormal noise, the motor is heated seriously, the shell is charged, the switch trips, and it cannot be started. So stop the machine immediately for inspection. In order to ensure safety, maintenance is not allowed during the operation of the fan. After maintenance, the machine can be started only after about five minutes of test run and no abnormal phenomenon is confirmed.
根據使用環境條件，不定期補充或更換釀酒風機設備軸承(電機封閉式軸承在使用壽命期間不需要更換)。為確保風機在運行過程中潤滑良好，加油次數不得少于1000小時/次。封閉式軸承和電機軸承應填充ZL-3鋰基潤滑脂，并且應填充軸承內外圈的2/3。嚴禁無油操作。
According to the use of environmental conditions, the bearing of brewing fan equipment should be supplemented or replaced irregularly (the closed bearing of motor does not need to be replaced during the service life). In order to ensure good lubrication of the fan during operation, the number of oil filling shall not be less than 1000 hours / time. The enclosed bearing and motor bearing shall be filled with zl-3 lithium base grease and 2 / 3 of the inner and outer rings of the bearing. Oil free operation is strictly prohibited.
釀酒設備風機應儲存在干燥的環境中，電機應防潮。風機露天存放時，應采取防雨措施。應防止風機在儲存和運輸過程中碰撞，以免損壞風機。
The fan of wine making equipment should be stored in a dry environment, and the motor should be moisture-proof. When the fan is stored in the open air, rain proof measures shall be taken. The collision of fans during storage and transportation shall be prevented to avoid damaging the fans.
釀酒設備風機的維護關系著設備在使用中是否能按照我們規劃的情況進行工作，如果還有其它問題，歡迎繼續關注http://m.tersatig.cn我們。
The maintenance of wine equipment fan is related to whether the equipment can work according to our plan. If there are other problems, please continue to pay attention http://m.tersatig.cn We are.
自動售酒機 2024-07-25 
